Impex CB-180 Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for CB-180 Impex
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 12 |
| Size: | 971 KB |
Show table of contents
Document Outline
- BEFORE YOU BEGIN...................................................................................…. 1
- IMPORTANT SAFETY NOTICES..................................................................…. 2
- HARDWARE IDENTIFIER.....…....................................................................…. 4
- ASSEMBLY INSTRUCTIONS........................................................................…. 5
- EXPLODED DIAGRAM……………………………………………………………… 9
- PARTS LIST...............................................................................................……. 10
- WARRANTY.................................................................................................….. 11
- ORDERING PARTS.......................................................................................… 11
- ASSEMBLY INSTRUCTION
- Insert the two Upper Backrest Supports (#8) into two Lower Backrest Supports (#9). Secure them with two M6 x 1 3/8” Hex Bolts (#20), four Ø ½” Washers (#25), and two M6 Aircraft Nuts (#28).
- Attach the side-holes on the Lower Backrest Supports (#9) to each end of the pivot on the Seat Support Frame (#6). Align the holes and insert a M10 x 6 7/8” Axle (#17) through the holes. Secure it with two Ø ¾” Washers (#23) and M10 Aircraft Nuts (#27).
- Place the Lower Backrest Board (#10) onto the Backrest Supports. Secure it with four M6 x 1 3/8” Hex Bolts (#20) and Ø ½” Washers (#25).
- Place the Upper Backrest Board (#11) onto the Backrest Supports. Secure it with two M6 x 1 3/8” Hex Bolts (#20) and Ø ½” Washers (#25).
- Attach the Leg Developer (#29) to the Leg Developer Holder (#7). Secure it with one M10 x 2 1/8” Hex Bolt (#19), two Ø ¾” Washers (#23), and one M10 Aircraft Nut (#27). Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel.
- Insert the Weight Post (#31) into the Leg Developer. Secure it with one M8 x 1 ¾” Hex Bolt (#22), two Ø 5/8” Washers (#24), and one M8 Aircraft Nut (#26).
- Insert the Foam Tube (#30) halfway through the holes on the Leg Developer. Attach two Foam Rolls (#32) onto the Tube from both ends.
- 20 M6 x 1 3/8” Hex Bolt 8