Impex CB-180 - Manual (Page 9)

STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#29) to the Leg Developer Holder (#7). Secure it with one
M10 x 2 1/8” Hex Bolt (#19), two Ø ¾” Washers (#23), and one M10 Aircraft Nut (#27).
Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel.
B.) Insert the Weight Post (#31) into the Leg Developer. Secure it with one M8 x 1 ¾” Hex
Bolt (#22), two Ø 5/8” Washers (#24), and one M8 Aircraft Nut (#26).
C.) Insert the Foam Tube (#30) halfway through the holes on the Leg Developer. Attach two
Foam Rolls (#32) onto the Tube from both ends.
DIAGRAM 4
8