Datamax-O'Neil MP Compact4_MP Compact4 Mobile Mark II Peel Off Option Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for MP Compact4_MP Compact4 Mobile Mark II Peel Off Option Datamax-O'Neil
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 4 |
| Size: | 135 KB |
Show table of contents
Document Outline
- Overview
- This document describes the contents, installation, and use of the Peel Off Option option for the MP Compact printers. After verifying the contents of the kit and the tools needed, follow the steps below to install and begin using the option.
- For your safety and to avoid equipment damage, always turn ‘Off’ power and unplug the printer’s power cord before beginning this installation and when performing service.
- Contents of the Peel Off Kit
- This kit contains the following item:
- ( 1 x Peel Off
- ( 4 x Screw (MC6S 5x12)
- ( 4 x Spacer
- ( 4x Lock Washer
- ( 1 x Peel Off Bar
- ( 2 x Screw (MRX 3x6)
- ( 2 x Washer (FZB 3.2)
- Tools Required
- To install this option, you will need
- ( Allen Key, 3mm
- ( Phillips Screwdriver
- Installation
- 1. Remove the print roller, see Operators manual for this procedure.
- 2. Mount the Peel Off Bar.
- 3. Fasten it with the 2 screws (MRX 3x6) and washers supplied in the kit.
- 4. Reinstall the print roller.
- 5. Remove the protection cover by releasing the 2 screws. Place the Printer up side down.
- 6. Remove the plastic plug from the printer.
- 7. Put the drive belt around the drive wheel inside the printer. Be careful not to damage the belt.
- 8. Place the Peel Off unit on the printer. Fasten with the four screws, spacers and lock washers. It is important to mount the Peel Off Kit parallel to the printer.
- 9. Place the belt around the wheel on the Peel Off unit.
- 10. Mount the print protection cover and tighten with the two screws.
- 11. Remove the tear off edge from the printhead.
- 12. Turn the locking bar 180º
- 13. Attach the Peel Off Kit with printer to the Mobile plate.