Datamax-O'Neil MP Compact4_MP Compact4 Mobile Mark II Peel Off Option - Manual (Page 3)

Installation
1. Remove the print roller, see
Operators manual for this procedure.
2. Mount the Peel Off Bar.
3. Fasten it with the 2 screws (MRX 3x6)
and washers supplied in the kit.
4. Reinstall the print roller.
2
3
5. Remove the protection cover by
releasing the 2 screws. Place the
Printer up side down.
6. Remove the plastic plug from the
printer.
7. Put the drive belt around the drive
wheel inside the printer. Be careful
not to damage the belt.
8. Place the Peel Off unit on the printer.
Fasten with the four screws, spacers
and lock washers. It is important to
mount the Peel Off Kit parallel to the
printer.
9. Place the belt around the wheel on
the Peel Off unit.
10. Mount the print protection cover and
tighten with the two screws.
8
11
11. Remove the tear off edge from the
printhead.
12. Turn the locking bar 180º
13. Attach the Peel Off Kit with printer to
the Mobile plate.
8
13
12
2