HP ISCSI SR2122 - Manual (Page 21)

Serving Fibre Channel Storage to the SR2122
21 iSCSI SR2122 Storage Router: Getting Started Guide
Figure 7: Virtual Disk Properties Entry
Note: If using SR2122 Cluster mode the WWPN for a FC port on each SR2122 cluster member
must be added to the HSV110 Unit.
The SR2122 should now be able to present ‘iSCSI DISK04’ as storage to iSCSI Initiators.
Presenting VA LUNs to the SR2122
VA storage volume must be pre-configured before the LUN(s) can be detected and recognized
by the SR2122. A VA can be configured either through Virtual Front Panel (VFP) via RS232
or HP SureStore Command View Storage Device Manager (SDM).
Note: Although XP's HP Storage Works Secure Manager VA can configure VA LUNs to be
selectively presented for SR2122's FC port, it is not supported at this time. Currently, the entire set of
LUNs configured on the VA's Fibre channel port is presented to the SR2122. It is required to have
this port dedicated to the SR2122 fabric zone.
Additional required configurations are:
1. Set the Fibre Channel HOST MODE: Linux or Win2k (to reflect Linux OS orWin2K)
2. Select the FIBRE TOPOLOGY (depends on configuration)
No additional configuration is required for running an SR2122 in cluster mode, since the other
SR2122's FC port is also on the same fabric zone and has the same access to the LUNs on the
VA array's Fibre channel port.
The SR2122 should now present the LUNs as storage to the iSCSI initiator.