HP M8201R - Manual (Page 41)

Hardware Replacement Procedures
M8201R Fibre Channel to SCSI Router Installation and User’s Guide — 529971-005
6 -3
Fibre Channel to SCSI Router Replacement
7. Place the old Fibre Channel to SCSI router aside.
8. Install the new Fibre Channel to SCSI router. Refer to section 3 Installing the Fibre
Channel to SCSI Router for the NonStop NS-Series Server when installing a new
Fibre Channel to SCSI router.
9. Enter in the following SCF command:
SCF> ALTER TAPE TAPE1, WWN 100000E00200F00
The WWN (Worldwide Name) is on the rear of the Fibre Channel to SCSI Router
as shown in
Figure 6-3 on page 6-3.
10. Power on the tape drive. See Figure 6-1 on page 6-1 for the power switch location.
Then wait for it to perform its power-on-self-test (POST).
11. Start the tape drive in SCF by entering in the following command:
SCF> START TAPE $TAPE1
Figure 6-3. Rear View of the Fibre Channel Router
WWNN: 100000E00200F000
WWPN: 100000E00C00F000
ENET MAC ID: 00:E0:02:00:00:XY
WWN Name
WWP Name
Ethernet MAC ID
(Physical Address)