Hitachi 32HDT20 - Manual (Page 4)

ACCESSORIES
4
1. Remote Control Unit CLU-5723TSI (P# HL01823). 5. Two IR Mouse cables (P# EY01641).
2. Two “AA” size, 1.5V batteries (P# EQ00021). 6. Speaker Accesories (42HDT20 only).
3. Two Power Cords (P# EV00832). 7. Wall Mount Unit WM20 (Optional).
4. Monitor Connection Cable (P# EW07193). 8. 32HDT20 Stand (P# H520441) (Optional).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new “AA” size batteries for the remote control. When replacing old batteries, push them towards the springs
and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
BOTTOM VIEW
Lift up on tab to
remove back cover.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
CAUTION: The plasma display wall mount unit WM20 is for use only with Hitachi model 32HDT20 and 42HDT20.
REMOTE BATTERIES POWER CORD MONITOR IR MOUSE
CONTROL CONNECTION CABLE CABLE
3. 4. 5.
POWER
TV VCR CBL
DVD
1 2
4 5 6
3
7 8 9
0 INFO SLEEP
A/V NET
EXIT MENU
CH VOL
MUTE
PIP PIP CH
SWAP
FREEZE
PIP MODE
PIP ACCESS
VIDEO
SOURCE WIZARD
REC
SELECT
TV/RGB ASPECT
STB
ANT
LAST CH
VCR PLUS+
SVCS
GUIDE/TV
SC HD
VID 1
VID 2 VID 3 VID 4
VID 5
TAPE CD AMP
MODE
CLU-5723TSI
SPEAKER ACCESSORIES
(42HDT20 ONLY)
1. 2.
WALL MOUNT UNIT WM20
(OPTIONAL)
6.
32HDT20 TV STAND SPD32
(OPTIONAL)
7. 8.
Check to make sure you have the following accessories before disposing of the packing material.