Huffy M731321 - Manual (Page 11)

11 11/05 ID# M731321
While maintaining alignment, bounce assembly and bottom pole section (6) together as shown
until they no longer move toward identification sticker.
5
4
6
3.
WOOD SCRAP
(NOT SUPPLIED)
Align dimple of middle pole section (5)
into trough of bottom pole section (6)
as shown.
IMPORTANT!
HOLE
DIMPLE
Bottom pole
5"
1-1/2"
ID
STICKER
Bottom pole
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-1/2"
BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!