HP BL465C - Manual (Page 30)

Removal and replacement procedures 30
To replace the component:
1. Install the mezzanine card. Press down above the back side of the connector to seat the card.
2. Install the access panel (" Access panel " on page 24 ).
3. Install the server blade.
HP Smart Array E200i Controller cache module
To remove the component:
1. Power down the server blade (on page 23 ).
2. Remove the server blade (on page 23 ).
3. Remove the access panel (" Access panel " on page 24 ).
4. Remove all hard drives (" Hard drive " on page 25 ).
5. Remove all hard drive blanks (" Hard drive blank " on page 24 ).
6. Remove the hard drive backplane (" Hard drive backplane " on page 28 ).
7. Remove the front panel/hard drive cage assembly (" Front panel/hard drive cage assembly " on
page 28 ).
8. Remove the USB key, if any (" System board components " on page 58 ).