Hand Held Products 4620 - Manual (Page 25)

IMAGETEAM™ 2020/4620 System Manual 1 - 5
5. Program the base for the keyboard wedge interface. See "Keyboard Wedge
Connection" on page 2-1.)
6. Verify the base operation by scanning a bar code from the Sample Symbols
in the back of this manual.
Connecting the Base with USB
A base can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the base and to the computer.
2. Program the base for the USB interface by scanning the appropriate
programming bar code.
3. Verify the base operation by scanning a bar code from the Sample Symbols
in the back of this manual.
For additional USB programming and technical information, refer to the Hand
Held Products “USB Application Note,” available at
www.handheld.com .