Hand Held Products 4620 - Manual (Page 166)

9 - 2 IMAGETEAM™ 2020/4620 System Manual
OCR Fonts
Default All OCR Settings turns off all OCR capability in the imager, so the
imager will be able to scan linear, stacked, matrix, and composite bar codes, but
not OCR fonts. In addition, any OCR templates you have created are erased.
The eight digit default templates are reinstated for any future use of the
OCR On
codes listed below.
< Default All OCR Settings >
OCR
Note: OCR symbols can misread when scanned sideways or upside down. Use
Working Orientation , page 4-19, if your OCR symbols will not usually be
presented upright to the imager.
Only one OCR symbology can be read at a time.
OCR-A On allows you to scan characters in the OCR-A font. The default setting
allows you to scan any eight digit combination. If you have created an OCR
template, character combinations that fit the template can be scanned (see
Creating an OCR Template , page 9-5).
OCR-B On allows you to scan characters in the OCR-B font. The default setting
allows you to scan any eight digit combination. If you have created an OCR
template, character combinations that fit the template can be scanned (see
Creating an OCR Template , page 9-5).
OCR-A On
OCR-B On