Hitachi DZ-BD10HA - Manual (Page 101)

101
Ad
di
ti
on
al I
n
fo
rm
a
tio
n
Not displayed
normally in the disc
navigation screen. BD, DVD-RAM, DVD-RW(VR mode), SD Card
recorded on this camcorder and edited on another device
may not be displayed normally in the disc navigation
screen. In this event, use “Update control info.”.
If too much time is required to display the HDD disc
navigation screen, try the following.
1 Press
, then press MENU.
2 Select “Disc setting” or “HDD setting” or “Card
setting” by pressing e/f, then press the
confirmation button.
The “Update control info.” confirmation screen
appears.
3 Select “YES” by pressing d, then press the
confirmation button.
Update of control information will begin. While
“Updating...” is being displayed, a black screen may
appear (and time may be required).
(There are some BD/DVD/Card which cannot be used
even by following the above procedures.)
—
The disc navigation
screen does not show
more than 3,999
stills from the
inserted card. If the inserted card contains more than 3,999 still
pictures, only 3,999 stills can be shown in the disc
navigation screen. However, it is possible to play back
more than 3,999 pictures.
—
Photos on a card
cannot be played
back. This camcorder can play back image data recorded onto
memory card using other digital cameras conforming to
DCF standards. However, depending on the recording
condition of the image data taken by other digital
cameras, blue thumbnails (see * of the illustration below)
appear, and playback of these images may not be
possible.
—
It takes some time to
play back photos. Stills with a large number of pixels will take more time to
appear.
—
Symptom Cause and Correction
Reference
page
0025/0030
Disc Navigation
10/ 1/2008 10:10:10 AM
SELECT
All Scenes
PLAY EXIT SEL
Fig. 1
*