Testing the hardware, Restoring defaults, Table 5-1 – Honeywell ULTRAKEY LITE HJC5000 User Manual
Page 67: Hjc5000 ultrakey lite controller default settings

UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A
67
08/10
Testing the Hardware
1.
Log into the controller.
2.
From the System Set: Config menu, press the LCD
up/down arrow keys to scroll to Hardware Test. Press Ent.
3.
Press the LCD up/down arrow keys and press Ent to select one or all of the following
test options:
•
Key: When you press a key, the key value and its state is displayed on LCD.
•
Joystick: When you move the joystick, values which present the PTZ (pan, tilt,
zoom) positions of the joystick are displayed on the LCD.
•
Serial port: Confirms that the controller serial port is functioning.
•
Slider: When you rotate the touch pad, specific values are displayed on the LCD.
4.
Press Alt > Clr to exit from these test menus.
Restoring Defaults
1.
Log onto the controller.
2.
Use the LCD up/down arrow keys to scroll to Restore
Default in the System Set: Config menu, then press Ent.
A confirmation message Restore Defaults? appears in
the display.
3.
Press the LCD up arrow key to select Yes or No.
•
Select Yes, then press Ent to restore the defaults.
•
Select No, then press Ent to cancel.
Configuration
Hardware test
Configuration
Restore default
Table 5-1
HJC5000 UltraKey Lite Controller Default Settings
Settings
Protocol
Network Settings for the Keyboard
IP
192.168.1.9
Net Mask
255.255.255.0
GateWay
192.168.1.1
DNS
192.168.1.1
Default Mode: VideoBlox
Maxpro Mode
Keyboard ID
1
Serial Port Mode
RS232
Server Port
26026
Server IP
192.168.1.10
Joystick Speed
Normal
Baud Rate
19200 bps