Step 4: configuring the dynamic keys, Figure 4-15, Serial port configuration tab – Honeywell ULTRAKEY LITE HJC5000 User Manual
Page 63: Figure 4-16, Ip configuration tab
UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A
63
08/10
4.
Click Apply to save the configuration, Cancel to exit without saving or Default to
restore all factory default values.
Figure 4-15
Serial Port Configuration Tab
Step 3B: Configure the Controller for an Ethernet Connection
1.
From the side menu, click IP Configuration.
2.
In each of the fields, enter IP address, subnet mask, gateway and DNS values.
3.
Click Apply to save the configuration, Cancel to exit without saving or Default to
restore all factory default values.
Figure 4-16
IP Configuration Tab
Step 4: Configuring the Dynamic Keys
You can configure the hard keys on the web server.
1.
From the side menu, click DynKey Configuration.