HANNspree LT12-23U1-000 - Manual (Page 38)

37
3
Press SWAP from the remote control to
switch the focus from the PIP to the
main source. The PIP identification line
disappears and the PIP window border
disappears.
4
Press POSITION from the remote
control to move the PIP window to one
of the four corners of the screen as
shown.
5
Press PIP/POP to switch to
picture-outside-picture (POP) mode.
The two signals are displayed
side-by-side.
6
Press PIP/POP again. The screen
displays the main source signal again.
MAIN - TV CH 007
MAIN - TV CH 007
PIP - CATV CH 056
MAIN - TV CH 007