Honeywell SYSTEM OVERVIEW N7003V3 - Manual (Page 48)

– 48 –
Quick Guide To System Functions
FUNCTION PROCEDURE COMMENTS
Check Zones Press [ ✱]. To view faulted zones when is system not ready
Display All
Descriptors
Press and hold [ ✱] for 5 seconds. Displays all alpha descriptors programmed by
installer.
Arm System Enter code.
Press arming key desired (AWAY,
STAY, INSTANT, MAXIMUM).
Arms system in mode selected.
Disarm System Enter code. Press OFF [1]. Disarms system and silences alarms.
Bypass Zones Enter code. Press BYPASS [6].
Enter 2-digit zone number(s). Bypassed zones are unprotected and will not
cause an alarm if violated.
Chime Mode Enter code. Press CHIME [9]. Keypad will sound if doors or windows are
violated while system disarmed.
Test Mode Enter code. Press TEST [5] Activates alarm sounder and allows sensors to be
tested.
View Messages Press and hold [0] for 5 seconds Message from central station will appear.
View User
Capabilities
Enter user’s code. Press [ ✱] + [✱]. Displays partitions & authority levels assigned to
the user.
GOTO Partition Enter security code. Press [
✱].
Enter partition number (1-2).
Allows a user at one keypad to perform functions
in another partition, (user must be authorized).
Self-Help Press and hold any function key for
at least 5 seconds.
Will display abbreviated instructions for the key
pressed.
Add a User Enter master/manager code.
Press CODE [8].
Enter new user’s user number.
Enter code for that user.
Enter authority for that user in this
partition (1-5).
Follow prompts, 1=Yes, 0=No.
Master & Manager level users can add users to
the system, each with its own code and
authority level.
Change a
User’s Code
Enter master/manager code.
Press CODE [8].
Enter user’s 2-digit number.
Enter new code for that user.
Press 0 (No) at prompt. Master & Manager level users can change their
own or other users’ codes.
Delete a User Enter master/manager code.
Press CODE [8].
Enter user no. to be deleted.
Enter master/manager code.
Press 1 (Yes) at prompt. Master & Manager level users can delete users.
A user can only be deleted by a user with higher
authority level.
Access Control Enter security code. Enter 0. Activate access relay for current partition.
Enter security code. Press [#]
Enter 71 or 72. Activate output device as programmed. Control Output
Device
Enter security code. Press [#]
Enter 70. Activate output device manually