Honeywell SYSTEM OVERVIEW N7003V3 - Manual (Page 37)

– 37 –
Event Log Procedures
General Information
The system has the ability to record
various events in a history log wherein
each event is recorded in one of five
categories (listed below), with the time and
date of its occurrence. The Event Log holds
up to 100 events, with the oldest event
being replaced by the logging of any new
event after the log is full. Using an alpha
keypad, the Event Log can be viewed one
category at a time, or can display all
events, regardless of category (ALL
EVENT LOG). The system also allows
selection of displaying the COMPLETE log,
or only those events occurring since the
last installer service (RECENT). In
addition, events in a partition can be
viewed by users authorized to access that
partition. Note that events are displayed in
chronological order, from most recent to
oldest.
To Display The Event Log
1. Enter CODE + [#] + [6] + [0]
2. Select the display mode.
RECENT: Displays only those events
occurring since last Event Log Clear
command was executed.
COMPLETE: Displays complete event
log (up to 100 events).
Press the desired key, 0 or 1.
ENTER 0 = RECENT
1 = COMPLETE
3. Select the partition, 0-2.
Enter the partition number for the
partition whose events are to be
displayed.
Entering 0 (NO) will display all
partitions’ events.
SCAN LOG BY PART
0=NO 1-2=PART #