Honeywell SYSTEM OVERVIEW N7003V3 - Manual (Page 38)

– 38 –
Event Logging Procedures (continued)
4. Use the [3] & [1] keys (for next and
previous categories respectively) to
display the categories of events.
Press [8] to select a category and
display the first event. Press [8] again
for each subsequent event.
Shows burglary alarm occurred in zone
3 (C03) of partition 1 (P1), at 12:02AM
on January 1.
P1 01/01 12:02AM
BURGLARY C03 Typical
Event Log
Display
After the last event has been
displayed, the END OF EVENT LOG
message appears for a few seconds,
then the system automatically displays
the RECENT/COMPLETE mode select
screen again (see step 2).
5. To EXIT the Event Log:
Press [
4] at any time.
ALARM EVENT LOG
TYPE CCC
UUU
Typical
Category
Select Screen
ALARM EVENT LOG
Displays time and date for zones that
have either caused an alarm or have been
restored in the selected partition.
CHECK EVENT LOG
Displays time and date for zones that
have caused a trouble or supervisory
condition in the selected partition.
BYPASS EVENT LOG
Displays time and date for zones that
have been bypassed in the partition.
OPEN EVENT LOG
Displays time, date and user number or 6-
character descriptor for the user, if
programmed, for each arming and
disarming of the system for the partition
selected.
SYSTEM EVENT LOG
Displays time and date for system
problems, such as AC Loss, low battery,
etc., regardless of partition.
ALL EVENT LOG
Displays all categories of events in
chronological order.
See your Installer for
additional information
concerning the event log.