Honeywell SYSTEM OVERVIEW N7003V3 - Manual (Page 17)

– 17 –
Security Codes & Authority Levels (cont’d)
To Add a User
IMPORTANT: Temporary users should not be shown how to use any system
function they do not need to know (e.g. bypassing protection zones).
CODE
1. Enter Master or Manager code and press the 8 key.
2. Enter the new user’s 2-digit User Number (01-69).
3. Enter 4-digit security code for that user. The following prompts will
appear.
ADD NEW USER?
0 = NO , 1 = YES
Enter 1 to add a new user code. Entering 0 will
change the existing user’s code to the code entered
in step 3. See Changing A User’s Code section.
USER NUMBER = 03
ENTER AUTH. LEVEL
Enter the authority level, 1-6, for this user within
this partition.
1=master
2=manager 3=operator A
4=operator B 5=operator C 6=duress code
RF BUTTON ?
0 = NO , 1 = YES
This prompt will appear if a 5800 series button
transmitter has been supplied and has not yet been
assigned to a user. Press 1 if a button transmitter
will be assigned to this user. Otherwise press 0.
ENTER BUTTON ZN #
(01-64)
If assigning a button transmitter, this prompt will
appear. Enter the button’s zone number (see your
installer for zone number).
MULTI-ACCESS ?
0 = NO , 1 = YES
If you as a user have access to the other partition,
the keypad will prompt for ability of this new user
to access (GOTO) those partitions. Press 0 (NO) or 1
(YES). If no, the system activates this user code and
exits “Add a User” mode. If yes, the keypad prompts
for the Global Arm option for this user.
GLOBAL ARM ?
0 = NO , 1 = YES
Press 1 (YES) if this user will be allowed to try to
arm more than one partition at the same time.
Press 0 if this user will arm only his assigned
partition.