Harbor Freight Tools 96154 - 11HP - Manual (Page 7)

Page 7 SKU 99856-96154 for technical questions, please call 1-800-444-3353.
ASSEMbLy INSTRucTIONS
TO MOuNT THE ENGINE
IMPORTANT: If you have any doubts about your ability to perform the following
assembly procedures, you should have a qualified service technician perform the
assembly for you.
figure A
Mounting
Holes
Mounting
Holes
Located near the Crankshaft (16 - page 16) are different-sized mounting holes with
which to mount the Engine to your power equipment unit. (See figure A.)
Set the Engine side-by-side to the power equipment unit, and align the mounting
holes of the Engine with the mounting holes in the power equipment unit. NOTE:
There are different patterns of mounting holes available. Use the mounting holes
that best match the ones on the power equipment unit. (See figure A.)
Use hardened steel Bolts, Washers, Lock Washers, and Nuts (not included) of the
appropriate diameter and length to secure the Engine to the power equipment unit.
(See figure A.)
cAuTION! check to make sure the bolts, Washers, Lock Washers, and the
Nuts used dO NOT come in contact with any moving part of the Engine and
power equipment unit.
NOTE: Refer to the power equipment unit’s owner manual for instructions on how
to properly install a belt drive pulley, chain drive gear, etc. onto the Crankshaft
(16 - page 16) of the Engine.
1.
2.
3.
4.
5.
6.