Printing to the floor – HP StudioJet User Manual

Page 38

Ioline FlexJet E User Guide

Printing to the Floor

With careful setup and constant supervision, the printer will print

markers directly onto the floor. This method is NOT intended for

printing long markers or unattended printing.
1.

Thread the paper on the front of the machine. It should drape

off the platen, over the feed roll, and onto the floor.

Set an origin normally and begin plotting. Make sure that the

paper piles smoothly onto the floor. If it bunches up, it may

catch on the moving carriage and tear.

If the paper bubbles or

wrinkles while it flows

over the platen surface,

the carriage might catch the edge

of the paper and tear it, causing

a paper jam. Make sure that the

paper is smoothly collecting on

the floor to avoid paper jams.

Caution

The front dancer bar should not be

used when plotting to the floor.

Note