Hitachi VT-FX6510A - Manual (Page 70)

PROBLEM GUIDE / MAINTENANCE
PROBLEM GUIDE / MAINTENANCE
Problem guide
No power Make sure the VCR is plugged into an AC outlet.
Remote control doesn't work Make sure the batteries are fresh, and properly installed.
Won't record Safety tab has been removed from cassette (VCR will
automatically eject the tape).
Won't play back Make sure the TV/VCR switch is set to the VCR mode.
Make sure the TV is set to the VCR channel (3 or 4) or AUX (if
using direct audio/video hookup).
Won't make timer recordings The VCR power must be turned off to activate timer recording.
Clock is not set correctly.
Programs entered incorrectly.
Programs exceed the length of the cassette. Use the EP
recording speed for maximum programming.
Safety tab has been removed from cassette.
Snowy picture in playback Snow or picture noise is normal during search, still, and slow
Playback.
Head cleaning may be required.
Tape is worn or of inferior quality - adjust tracking controls.
Snowy picture in normal TV
viewing Check antenna or cable connections.
Clock shows --:-- Power has been interrupted - reset the clock.
Reset the clock.
Erratic VCR display Push the reset switch with a sharp pointed instrument (pen,
toothpick, etc.).
Maintenance
Regular periodic maintenance is required to maintain optimum VCR performance. Such maintenance and
adjustments should not be attempted by the user. Please consult your service dealer for further information.
NOTE: Dirt accumulation on the video heads will cause the playback picture to become noisy. The VCR
may require the video heads to be professionally cleaned by a qualified service dealer.