Hitachi VT-FX6510A - Manual (Page 59)

EASY DELAYED RECORDING WITH THE VCR PLUS+ SYSTEM
4 Press the number buttons to enter the PlusCode number of the program you want to record.
Note: This number can be up to eight digits. If you enter a wrong digit, press the CLEAR button and enter
the correct one.
5 Press the ENTER button to enter the PlusCode number in the VCR's memory.
The start time and channel will appear. Check the details of the program.
If you have installed a cable box (see page 23), the cable box output channel will appear in the channel
display.
If "Err" flashes for about five seconds, check the PlusCode number of the program and enter it again.
6 Press the PROGRAM button to complete your programming or continue with additional
programs.
The delayed recording indicator ill display on the VCR.
This tells you that the VCR will automatically record at the times and dates you have programmed.
Note: If a cassette has not been inserted or a cassette without safety tab has been inserted, the delayed
recording indicator will flash to warn you. The cassette without safety tab will be ejected automatically. Be
sure to insert a cassette with safety tab intact.
When you have set up all the timed recordings you want:
Don't forget to load a videocassette (with the safety tab still attached) to record on.
If you have installed a cable box (see page 23), turn on the cable box and select the channel you want to
record on the cable box before recording starts.
Important: Your timed recording settings take effect when you turn off the power on the VCR.
Caution of VCR Plus+ Recording
After entering a PlusCode number, check the information displayed with the "PROGRAM REVIEW". If
there is (are) any unnecessary program(s), please cancel or correct it (them). Please refer to page 49,
"Reviewing what you have programmed".
To go into the recording mode:
1. Press the POWER button to turn the VCR on.
2. Turn on TV and select the video channel (3 or 4).