Home Automation SECURITY SYSTEM - Manual (Page 67)

Set up Miscellaneous
To configure Miscellaneous items in the system, from the Set Up menu, press the 6 (MISC) key.
High Security Mode
In High Security Mode, the Master or Manager code is always required to do the following functions:
•
Any Control functions
•
Any Temperature Control
•
View the Event Log
•
Access the system from a local phone
With High Security Mode Off, no code is required to access a local telephone.
If your system is set up with High Security On, the display will request the Master or Manager code whenever you select one of
these functions, even if the security system is Off. Simply enter your Master or Manager code.
Your system was shipped from the factory with High Security Off, which allows you to view the event log and access the local
phones without having to enter a code. In most residential applications, this is appropriate. If you have a commercial installation,
or would like added protection from unauthorized access to the system, you may wish to turn on High Security Mode.
Announce Alarms
If a Two-Way Audio Module is being used in a system, this item enables the system to speak the type of alarm and zone over a
speaker on premises. When an alarm first occurs, the siren is activated. After a few seconds, the siren is turned off and the type
of alarm is announced. The siren is then reactivated.
The default for Announce Alarms is No.
Enable Freeze Alarm
If there are one or more Thermostat or PESM in a system, they can also be used to detect a freeze condition - See Freeze Alarm.
The default for Enabled Freeze Alarm is No.
Flash For Alarm
You may enter one unit number that will flash On and Off continuously when the alarm is activated. This should be an outside
light to alert neighbors and police to your property if the alarm is activated.
The default Flash For Alarm is Unit 2. You may enter one number for the unit number you wish to have flash, or ' 0 ' for none.
House Code Format
The House Code can be configured to use the Standard (Preset Dim Command), Extended Code (Level Command), Lightolier's
Compose Mode, UPB (open transmission format), Lutron’s RadioRA transmission format, HAI Lighting (HLC), or CentraLite
transmission format.
HC 1 FORMAT: 5
HAI LIGHTING #=CHNG
To change format for the House Code, press the ' # ' key, and then use the arrow keys to scroll through the list of formats. Press
the ' # ' key to select the desired format
.
63