Home Automation SECURITY SYSTEM - Manual (Page 46)

When you are finished with the voice menu, press the 9 (Good-Bye) key. The OmniLT will say, "GOOD-BYE" and hang up.
From an in-house phone, the dial tone will return. From a remote phone, you will hear a click as the OmniLT hangs up. It is
recommended that you press 9 to terminate a remote call. If you don't, the OmniLT will hang up anyway after about 15 seconds.
Recording Your Address
The "Phone" menu allows you to record and verify your address. The address is used only for the VOICE dial out feature.
Press 8 from the MAIN MENU to get to the PHONE menu.
"PHONE - PLEASE CHOOSE: [3 INTERIOR]
8 PLAY ADDRESS, 9 RECORD ADDRESS *: CANCEL."
To play the current address, press the 8 key.
To record the address, press the 9 key and enter the Master code.
"RECORD ADDRESS - [BEEP]
At the [BEEP], record your name and address.
"ADDRESS IS: (ADDRESS IS PLAYED)."
When a Two-Way Audio Module is being used:
If an optional Two-Way Audio Module is being used, this command also allows paging and listening to premises.
To talk or listen to the premises, press the 3 key.
"PLEASE CHOOSE: 2 TALK, 8 LISTEN, *: CANCEL."
- If no key is pressed, OmniLT will automatically switch to listen mode.
To talk to someone at the premises, press the 2 key.
To listen to the premises, press the 8 key.
- You cannot talk to anyone on premises in listen mode and you cannot listen to the premises while in the talk mode.
Panic Button over the Phone (# # # # # #)
On an in-house phone only, you can activate the Police Emergency keys by picking up the phone and pressing the # key 6 times.
This activates the sounder immediately.
The first # that you press logs you in, as usual, then the next 5 presses of the # key activate the alarm. If you are already logged
into your system, then it takes only 5 presses of the # key to activate the emergency alarm. To prevent accidental activation of the
panic feature over the phone, you must press the # key 5 times, all at once. If you pause for more than 2 seconds, or press any
other key, the panic activation is canceled. The OmniLT will say "CANCEL".
Note that the Panic Button Over the Phone feature only works if you are logged into the system. In an emergency, if you wish to
set off the alarm, simply pick up the phone and repeatedly press the # key until the alarm sounds. Be aware that, under some
circumstances, it may be smarter to dial 911 or your police department directly. Also be aware that your telephone will be
unusable while the OmniLT dials out.
PC Access
OmniLT is capable of communicating with an IBM compatible personal computer (PC). The PC can be local (in-house) or
remote. The PC must be equipped with a modem or serial port and running PC Access software. The OmniLT has a built-in
modem and can be accessed over the telephone or over a direct serial connection (RS-232/RS-485 through an optional serial
interface module). If you wish to use your PC to configure, program, and check the status of your OmniLT, contact your dealer
for the appropriate software for your PC.
42