Home Automation SECURITY SYSTEM - Manual (Page 50)

The times and days are changed by pressing the ' # ' KEY. Choose the 1 (TIME) key to change the On or Off times. You will be
prompted to enter the new time. AM/PM must be specified for the time if the AM/PM format is being used, otherwise the entered
time should be 13:00-23:59. Each item defaults to its current value. Press the up arrow key to select Sunrise and press the down
arrow key to select Sunset.
CODE X(ON/OFF)TIME:
1=TIME 2=DAYS
TIME: 8:00 AM
HHMM
↑
=RISE/AM
↓
=SET/PM
To change days, press the ' # ' key, then press the 2 (DAYS) key. You will be prompted to enter the day(s) that the code will be
valid. Press 1-7 for Monday - Sunday, 0 for Never, 8 for Weekdays, and 9 for Weekends.
DAY(S):
MTWTFSS
1-7=MON-SUN 0=NEVER
Duress Code
If you are forced to disarm the system against your will by an intruder, disarm it as you normally would, but use the Duress Code
instead of your normal code. The system will disarm normally. No sirens will sound, no lights will flash, but the OmniLT will
perform a silent dial out and say that this is a silent alarm.
To stop a silent dial out, turn your security system off by pressing OFF, then your code.
DURESS CODE:
0000-9999 0000=DISABLE
↑
Set Up Time
To set up time and date, from the Setup menu, press the 2 (TIME) key. You will be prompted to enter the new time
and date.
AM/PM must be specified for the time if that format is being used, otherwise the entered time should be 13:00-23:59.
Each item defaults to its current value.
TIME:
HHMM
↑
=AM
↓
=PM
DAYLIGHT SAVINGS TIME? (Are you currently observing DST)
0=NO 1=YES
ENTER
DATE:
MMDDYY
DAY OF WEEK:
1-7=MON-SUN
Set Up Programs
Your OmniLT can be programmed to do automated control and security functions on a time schedule or in response to an event
occurring in the system.
The OmniLT executes programs:
•
Once at a certain time on a certain date (One-Time Program)
•
On a certain date every year (Yearly Program)
•
Repeatedly (Repeating Programs)
•
In response to an event (Event Button Programs)
You can also conditionalize programs so that they only run under certain circumstances.
46