HandHeld Entertainment 4600r - Manual (Page 33)

2 - 1
2
Terminal Interfaces
Terminal ID
If your interface is not covered by a Plug and Play barcode from Chapter 1, then
refer to
Supported Terminals on page 2-2 through page 2-3 , and locate the Ter-
minal ID number for your PC. Scan the Terminal ID barcode below, then scan
the numeric barcode(s) from the Programming Chart inside the back cover of
this manual to program the imager for your terminal ID. Scan Save to save your
selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID barcode, then 0, 0, 3 from the Programming Chart inside the back
cover of this manual, then Save . If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the Programming Chart ,
scan the Terminal ID barcode, scan the digits, and the Save code again.
Note: After scanning one of these codes, you must power cycle your computer.
Terminal ID
Save