To configure stp parameters, Enable/disable stp, 4 to configure stp parameters – HP 6212 User Manual

Page 70: 5 enable/disable stp

Text mode
Original mode

70 May 2004 6212-A2-GB20-00

5.11.4 To configure STP parameters

STEP 1: Click on the Spanning Tree tab at the top of the Bridging screen.

STEP 2: Click on the Configure Port button.

STEP 3: Configure the parameters.

STEP 4: Click on the Apply button.

5.11.5 Enable/Disable STP

To enable or disable an STP entry, select the entry and then click on the Enable or Disable
Button, located at the bottom of the Spanning Tree screen. Note that if the entry is already
enabled the Disable button will be present; if the entry is disabled, then the Enable button will
be present.