Back panel, Back panel -3, Link. for more information, see – Honeywell DOLPHIN 99EX User Manual
Page 169: Rj45 ethernet ports
16 - 3
Back Panel
DC Power Jack
Use the power cable from Honeywell that comes with the Net Base to supply power to this
power jack. For more information, see
RJ45 Ethernet Ports
The Net Base contains two RJ45 Ethernet ports. You can connect the Net Base to an Ethernet-
compliant device to facilitate Ethernet communication to and from the terminal by plugging a
standard CAT-5 Ethernet cable into one of the two Ethernet ports provided. The second RJ45
Ethernet port can be used for connection to an additional device such as a printer, workstation,
eBase, or another Net Base.
Note:
The Net Base does not use a Spanning Tree Protocol (STP). When both RJ45 Ethernet ports
are used, do not connect both Net Base interfaces to the same layer 2 LAN.
Each Ethernet port has a dedicated green and yellow status LED.
Note: The terminal and Ethernet link must be set up properly to allow the terminal to communicate to other devices
and/or the Internet. For more information, see
Connecting the Dolphin Terminal to the Net Base
This color
and status
means…
Green
Flashing
Data transfer is in progress.
Solid
A connection has been established between the Net Base and
the Ethernet.
Yellow
Solid
Ethernet is connected at 100T.
Off
Ethernet is connected at 10T.
DC Power Jack
Two RJ45 Ethernet Ports
Green LED
Yellow LED