Bottom panel, Power, Connecting power to the ebase – Honeywell DOLPHIN 99EX User Manual
Page 145: Bottom panel -5, Power -5, Connecting power to the ebase -5
13 - 5
DC Power Jack
Use the power cable from Honeywell that comes with the eBase to supply power to this power
jack. For more information, see
Bottom Panel
For details on how to mount the eBase, see
Power
The terminal requires 12 Volts DC input for communications and battery charging; the power adapter on
the power cable converts the voltage from the power source to 12 Volts DC. Only the Honeywell 12VDC,
3A power supply provided with the ebase converts the voltage appropriately. The operating temperature
range is -10° to 50°C (14° to 122°F).
Honeywell recommends that you leave the eBase connected to its power source at all times, so that it is
always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Connecting Power to the eBase
1.
Plug the A/C power cord into the power adapter.
2.
Plug the power cable into the power connector on the back of the eBase.
3.
Plug the A/C power cord into a grounded power source. The Power/Dock LED on the eBase
illuminates solid red to indicate the eBase has power and no terminal is docked.
Compliance Label
Serial Number Label
MAC Address Label
!
Power Cable
A/C Power Cord
Power
Adapter