beautypg.com

Working with gps, Overview, Assisted gps support – Honeywell DOLPHIN 99EX User Manual

Page 129: Powering the gps module, Communication ports, Selecting the port, Com7, Chapter 11 - working with gps, Selecting the port -1 com7 -1

background image

11 - 1

11

Working with GPS

Overview

The Dolphin 99EX terminal contains an integrated GPS module that allows location tracking of workers
and vehicles, providing better utilization of field assets. Optional mapping and navigation software pro-
vides turn-by-turn driving directions and location information.

Assisted GPS Support

The operating system software does not inhibit nor explicitly support assisted GPS modes, which usually
requires installing a vendor-specific client on the terminal that communicates with the GPS module. This
client would then provide the almanac and/or ephemeris data for warm or hot start modes of operation,
allowing a lower time to first fix (TTFS). The Client must be configured on the terminal, active, and pro-
vide the data to the GPS module through the standard COM port.

Powering the GPS Module

The GPS module powers on automatically when accessed by a software application and powers off
automatically when that software application closes. You cannot manually power on and off the GPS
module.

Communication Ports

There are two ways to access the GPS module: through the actual COM port (COM7) or the GPS Inter-
mediate Driver. The method you use depends on the software application you are using. If the software
application requires the actual COM Port, set the operating system to use COM7. If the software applica-
tion requires the GPS Intermediate Driver, set the operating system to use the GPS Intermediate Driver.

Selecting the Port

1.

Tap

>

Settings > System > External GPS.

2.

In the GPS program port: drop-down list, select COM7 or GPD1
(the GPS Intermediate Driver) as required by the application.

Note: The GPS program port and hardware port cannot be the same value.

3.

Tap OK to save.

COM7

COM Port 7 can be set to the following baud rates:

• 4800
• 9600 (Default baud rate. Recommended for optimal performance.)
• 19200
• 38400

Other baud rates are not possible.

The baud rate selected on COM7 is the actual baud rate with which

the GPS communicates.