Bottom panel, Power, Connecting power to the homebase – Honeywell DOLPHIN 99EX User Manual
Page 135: Bottom panel -5, Power -5, Connecting power to the homebase -5, Section that follows
12 - 5
Bottom Panel
For details on how to mount the eBase, see
Power
The base requires 12 Volts DC input for communications, battery charging, and power output to the ter-
minal; the power adapter included with the base converts the voltage from the AC power source to 12
Volts DC. Use only the Honeywell 12VDC, 3A power supply provided with the base. The operating tem-
perature range is -10° to 50°C (14° to 122°F).
Honeywell recommends that you leave the base connected to its power source at all times, so that it is
always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Connecting Power to the HomeBase
1.
Plug the A/C power cord into the power adapter.
2.
Plug the power cable into the power connector on the back of the HomeBase.
3.
Plug the A/C power cord into a grounded power source. The base is now powered. The Power/Dock
LED on the HomeBase illuminates solid red to indicate the HomeBase has power and no terminal is
docked.
Compliance Label
Serial Number Label
!
Power Cable
A/C Power Cord
Power
Adapter