Epson 3260 - Manual (Page 73)

General problems
the lights on the control panel do not come on.
Check that the power cord is properly plugged into the
electrical outlet
If the electrical outlet is controlled by an
outside switch or
automatic timer, use a different outlet.
Plug another electrical device into the outlet to determine
whether the outlet is operating properly.
The lights come on briefly and then go off. The lights stay off
even when the power is turned on again.
Check that the printer’s voltage rating matches the voltage of
your electrical outlet If the voltages do not match, unplug the
printer and contact your dealer immediately. Do not reconnect
the power cord to an electrical outlet
Printing problems
The READY light is on but nothing is printed.
Check that the software is installed properly for your printer.
Check the software's printer settings.
Checkboth ends of the interface cable between the
printer and
the computer. Make sure this cable is
a shielded twisted-pair
parallel cable that meets both the printer and computer
specifications.
Using the Printer 3-17