Epson 3260 - Manual (Page 65)

See the following tables in this section.
For example, if you want to change the character table, press
the
FONT
button until the left
FONT light is flashing and
the right FONT light is on.
6.
Press the
FF
button to
change the setting. The READY light
turns on or off to show your selection, as indicated above.
Your new setting is saved automatically and remains in
effect until you change it
If you are changing the character table, page length, or TOF
(top-of-form) position, go to step 7 next. Otherwise, go to
step 8.
7. If you are changing the character table, page length, or TOF
position, you must make additional changes as shown in
the tables below. Press the
FF button until the set
of lights
(the FONT lights
and
the READY light) indicate your
selection. Then press the
FONT button to set the setting.
Using the Printer 3-9