beautypg.com

Care and maintenance – Dacor Transitional 30 Inch Double Electric Smart Wall Oven User Manual User Manual

Page 46

background image

46 English

C

ar

e and maint

enanc

e

Care and maintenance

5.

Repeat for the right (front and back)
slide mechanism of the rack.

6.

Open and close the rack several times
to distribute the lubricant.

7.

Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5, and 6.

8.

Close the rack, turn the rack right-
side-up, and then place in oven. See

Installing the Gliding rack

on page

35

.

NOTE

Do not spray the gliding rack with
cooking spray or other lubricant sprays.

Oven door

Don’t hand

Don’t hand
clean the

clean the
oven door

oven door
gasket.

gasket.

You may

You may
hand clean

hand clean
the door.

the door.

Use soap and water to thoroughly
clean the top, sides, and front of the
oven door. Rinse well. You may use a
glass cleaner on the outside glass of
the oven door. DO NOT immerse the
door in water.

DO NOT spray or allow

water or the glass cleaner to enter the
door vents.

DO NOT use oven cleaners,

cleaning powders, or any harsh
abrasive cleaning materials on the
outside of the oven door.

DO NOT clean the oven door gasket.

The oven door gasket is made of a
woven material which is essential for a
good seal. Care should be taken not to
rub, damage, or remove this gasket.

To lubricate the slides of the gliding rack

1.

Remove the rack from the oven. See
removing the gliding rack in the

Using

the gliding rack

section on page

35

.

2.

Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.

3.

If there is debris in the slide tracks,
wipe it away using a paper towel. (Any
graphite lubricant wiped away must be
replaced - See steps 4 through 7.

4.

Shake the graphite lubricant before
opening it. Starting with the left (front
and back) slide mechanism of the rack,
place four (4) small drops of lubricant
on the two (2) bottom tracks of the
slide close to the bearing carriers.

DOB30x977Dx_AA_DG68-01313A-01_EN+MES+CFR.indb 46

DOB30x977Dx_AA_DG68-01313A-01_EN+MES+CFR.indb 46

2023-03-14 오전 10:30:42

2023-03-14 오전 10:30:42