Epson EB-G5200W - Manual (Page 81)

81 Cleaning
You should clean the projector if it becomes dirty or if the quality of
projected images starts to deteriorate.
Cleaning the Projector's Surface
Clean the projector's surface by wiping it gently with a soft cloth.
If the projector is particularly dirty, moisten the cloth with water
containing a small amount of neutral detergent, and then firmly wring the
cloth dry before using it to wipe the projector's surface.
Cleaning the Lens
Use a commercially available cloth for cleaning classes to gently wipe the
lens.
Cleaning the Air Filter
Clean the air filter and the air intake vent when the following message is
displayed.
"The projector is overheating. Make sure nothing is blocking the air vent,
and clean or replace the air filter."
A
Remove the air filter cover.
Grip the air filter cover tab between your fingers and pull it straight
out.
Attention
Do not use volatile substances such as wax, alcohol, or thinner to
clean the projector's surface. The quality of the case may change or
become discolored.
Attention
Do not rub the lens with harsh materials or subject the lens to
shocks, as it can easily become damaged.
Attention
• If dust collects on the air filter it can cause the internal
temperature of the projector to rise, and this can lead to problems
with operation and shorten the optical engine's service life. Clean
the air filter immediately when the message is displayed.
• Do not rinse the air filter in water. Do not use detergents or solvents.
• When using a brush for cleaning, use one with long soft bristles,
and brush it lightly. If it is brushed too strongly, dust will be
ground into the air filter and cannot be removed.
Procedure