Samsung 30 Inch Slide-in Electric Smart Range Owner Manual - Manual (Page 59)

English 59
Maint
aining y
our applianc
e
Removing and reinstalling the oven door
How to remove the door
You can remove the upper door the same way you remove the full door.
CAUTION
• The door is very heavy. Be careful when removing and lifting the door. Do not
lift the door by the handle.
• Turn the power OFF before removing the door.
1. Open the door completely.
2. Pull the hinge locks down toward the door frame to the unlocked position.
Locked position Unlocked position
Hinge lock
3. Firmly grasp both sides of the door at the top.
about 5 °
Fig. 1 Fig. 2
4. Close the door to the door removal position, which is approximately 5 degrees
from vertical (Fig. 1).
5. Lift the door up and out until the hinge arm is clear of the slot (Fig. 2).
How to reinstall the door
You can replace the upper door the same way you replace the full door.
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Bottom
edge of
slot
Indentation
Hinge
arm
3. Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
Hinge lock
Locked position Unlocked position
5. Close the oven door.
NE63T8751_AA_DG68-01208A-00_EN+MES+CFR.indb 59 2020-03-27 2:47:51