Operating the oven – Samsung 30 Inch Slide-in Electric Smart Range Owner Manual User Manual
Page 50
50 English
Oper
ating the o
v
en
Operating the oven
Default Cavity
One cavity will be selected as a default in twin mode when oven turns on.
1.
Tap and hold
for 3 sec.
2.
Select
Default
Cavity
using the dial knob.
3.
Turn the dial knob to select Upper or Lower and push to save the changes.
Welcome Lighting
When you wake up the oven (such as using the dial knob, using the touch pad,
open the door), the knob lights blink each to welcome you.
Set the
Welcome Lighting
mode to On/Off. The default is on.
1.
Tap and hold
for 3 sec.
2.
Select
Welcome Lighting
using the dial knob.
3.
Turn the dial knob to select
On/Off
and push to save the changes.
Demo mode
This is used by retailers for display purposes only. In this mode, the heating
element does not operate.
1.
Tap and hold
for 3 sec.
2.
Select
Demo mode
using the dial knob.
3.
Turn the dial knob to select
On/Off
and push to save the changes.
Reset
You can reset your oven setting(More functions, System settings).
1.
Tap and hold
for 3 sec.
2.
Select
Reset
using the dial knob.
3.
Turn the dial knob to select
Cancel/Reset
.
CAUTION
Before reset the oven settings, turn off all oven and cooktop functions.
Temp. Unit (°F / °C)
Change the temperature format of the oven to Fahrenheit or Centigrade. The
default is Fahrenheit.
1.
Tap and hold
for 3 sec.
2.
Select
Temp. Unit
using the dial knob.
3.
Turn the dial knob to select unit and push to save the changes.
Calibrate Temp
The oven temperature has been calibrated at the factory. When first using the
oven, follow the recommended recipe times and temperatures. If it appears that
the oven is too hot or too cool, you can recalibrate the oven temperature. Before
recalibrating, test a recipe by using a temperature setting that is higher or lower
than recommended. The baking results should help you decide how much of an
adjustment is needed. The oven temperature can be adjusted by ±35 °F (±19 °C).
1.
Tap and hold
for 3 sec.
2.
Select
Calibrate Temp
using the dial knob.
3.
Turn the dial knob to adjust temperature value.
4.
Push the dial knob to save the changes.
NOTE
This adjustment does not affect the broiling or the self-cleaning temperature, and
is retained in memory after a power failure.
My Pattern
This function remembers and stores the cook settings frequently used by the user.
1.
Tap and hold
for 3 sec.
2.
Select
My Pattern
using the dial knob.
3.
Turn the dial knob to select On/Off and push to save the changes.
NE63T8751_AA_DG68-01208A-00_EN+MES+CFR.indb 50
2020-03-27 2:47:49