Samsung 30 Inch Slide-in Electric Smart Range Owner Manual - Manual (Page 23)

English 23
Sur
fac
e c
ooking
CAUTION
AFTER COOKING
• Do not touch the surface units until they have cooled down.
• The surface may still be hot and burns may occur if you touch the glass
surface before it has cooled down sufficiently.
• Immediately clean spills on the cooking area to prevent a tough cleaning
chore later.
• If cabinet storage is provided directly above the cooking surface, make sure
that the items are infrequently used and can be safely stored in an area
subjected to heat. Temperatures may be unsafe for items, such as volatile
liquids, cleaners, or aerosol sprays.
About the radiant surface elements
The temperature rises gradually and evenly. As the temperature rises, the radiant
element will glow red. To maintain the selected setting, the element will cycle
on and off. The heating element retains enough heat to provide a uniform and
consistent heat during the off cycle. For efficient cooking, turn off the element
several minutes before cooking is complete. This will allow residual heat to
complete the cooking process.
NOTE
Radiant elements have a limiter that allows the element to cycle ON and OFF, even
at the HI setting. This helps to prevent damage to the ceramic cooktop. Cycling at
the HI setting is normal and can occur if the cookware is too small for the radiant
element or if the cookware bottom is not flat.
NOTE
When you operate the knob, beep sounds once.
Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as
shown below.
01 05 03
02 04
06
01 Left Rear:
6", 1200 W 02 Left Front:
6"/9", 3600 W 03 Warming Center:
100 W
04 Right Front:
6"/9"/12", 3000 W 05 Right Rear:
6", 1200 W 06 Hot surface
indicator
NOTE
The knob illumination around the knob turns on when the knob is turned on.
NE63T8751_AA_DG68-01208A-00_EN+MES+CFR.indb 23 2020-03-27 2:47:40