beautypg.com

Samsung 30 Inch Slide-in Electric Smart Range Owner Manual User Manual

Page 53

background image

English 53

Maint

aining y

our applianc

e

Before a self-cleaning cycle

Fig. 1

Fig. 2

Don’t hand
clean the
oven door
gasket.

You may
hand clean
the door.

We recommend venting your kitchen
with an open window or using a
ventilation fan or hood during the self-
cleaning cycle.

Remove the wire rack, broil pan, broil
pan insert, all cookware, and any
aluminum foil from the oven.

Wipe up debris from the oven bottom.
(Fig. 1)

Residue on the front frame of the range
and outside the gasket on the door
will need to be cleaned by hand. Clean
these areas with hot water, soap-filled
steel-wool pads, or cleansers, such as
Soft Scrub. Rinse well with clean water
and dry.

Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for
the gasket to remain intact. If you
notice it becoming worn or frayed, have
it replaced. (Fig. 2)

Make sure the oven light bulb cover is
in place and the oven light is off.

NOTE

Remove oven racks and accessories before starting the self-clean mode.

How to run a self-cleaning cycle
1.

Make sure the oven door is closed completely and unlocked. And turn off all
oven and cooktop function.

2.

Tap

, and select

Cleaning

>

Self Clean

using the dial knob.

Then, select the cleaning time. (2 hour / 3 hour / 5 hour)

3.

Tap

START/SET

.

The oven door is locked automatically and the oven begins to heat up.

NOTE

You will not be able to start a self-cleaning cycle if the oven lock feature
is activated or if the oven’s temperature is too hot.

The oven door locks automatically. The display will show the cleaning
time remaining. It is not be possible to open the oven door until the
temperature drops to a safe/cool temperature.

The self-cleaning feature will not operate when the warming center is on.

4.

When the self-cleaning cycle is done, End will appear in the display and the
range will beep several times.

How to delay the start of self-cleaning
1.

Repeat steps 1 and 2 on 'How to run a self-cleaning cycle'.

2.

Select

Set Delay Start

.

3.

Set the time you want the oven to start self-cleaning using the dial knob.

4.

Tap

START/SET

.

The oven will start self-cleaning at your specified time.

How to turn off the self-cleaning feature

You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven.

1.

Press

OFF

.

2.

You will be able to open the oven door once the oven has cooled down for
approximately 1 hour.

NE63T8751_AA_DG68-01208A-00_EN+MES+CFR.indb 53

2020-03-27 2:47:49