Before you begin, Important, Important electrical safety—read carefully – GE Zoneline UltimateV10™ 8,900 BTU Vertical Terminal Air Conditioner Owners Guide User Manual
Page 17: Electrical requirements, Warning

49-5000561 Rev. 2
INST
ALLA
TION INSTRUCTIONS
Installation Preparation
IMPORTANT ELECTRICAL
SAFETY—READ
CAREFULLY
WARNING
RISK OF ELECTRIC SHOCK.
$OOHOHFWULFDOFRQQHFWLRQVDQGZLULQJ0867EH
installed by a qualified electrician.
)ROORZWKH1DWLRQDO(OHFWULFDO&RGH1(&DQGRU
local codes and ordinances.
)RUSHUVRQDOVDIHW\WKLV=RQHOLQHXQLWDQGFDVH
must be properly grounded.
3URWHFWLYHGHYLFHVIXVHVRUFLUFXLWEUHDNHUV
DFFHSWDEOHIRU=RQHOLQHLQVWDOODWLRQVDUHVSHFLILHGRQ
the nameplate of each unit.
'RQRWXVHDQH[WHQVLRQFRUGZLWKWKLVXQLW
• Aluminum building wiring may present special
problems—consult a qualified electrician.
• When the unit is not running there is still voltage to
the electrical controls.
• Disconnect the power to the unit before servicing by:
5HPRYLQJWKHEUDQFKFLUFXLWIXVHVRUWXUQLQJWKH
circuit breakers off at the panel.
2.
Disconnect the power cord from the unit.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all governing
codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the owner.
•
Note to Owner –
.HHSWKHVHLQVWUXFWLRQVIRU
future reference.
•
Proper installation is the responsibility of the
LQVWDOOHU&RPSOHWHGLQVWDOODWLRQRIWKH=RQHOLQH
shall not be accessible to the general public.
•
Product failure due to improper installation is not
covered under the Warranty.
•
7HDPOLIWLVUHFRPPHQGHGZKHQPRYLQJXQLW
•
installation procedures as described in these Questions? Call 844-GE4-PTAC (or 844-434-7822 ) or Visit our Website at: GEAppliances.com ELECTRICAL NOTE: All field wiring must comply with NEC and Wire Size Use ONLY wire size recommended for single outlet branch circuit Fuse/Circuit 8VH21/ on units rating plate. Proper over Grounding 8QLW0867EHJURXQGHGIURPEUDQFK circuit to unit, or through separate Wire Sizing Use recommended wire size given NOTE: Use copper conductors WARNING RISK OF ELECTRIC SHOCK. &DQFDXVHLQMXU\RUGHDWK7KLVDSSOLDQFHPXVWEH properly grounded. 8VH21/ outlet branch circuit. • Proper current protection is the responsibility of the owner. NOTE: Use copper conductors only. Recommended Branch Circuit Wire Sizes* Nameplate Maximum Circuit Breaker Size AWG Wire Size** $ N NSURGXFWVRQO\ $ $ AWG - American Wire Gauge 6LQJOHFLUFXLWEUHDNHUIURPPDLQER[ ** Based on copper wire, single insulated conductor DW C
instructions when installing this air conditioner.
REQUIREMENTS
local codes. It is the responsibility of the installer
to ensure that the electrical codes are met.
Breaker
current protection to the units is the
responsibility of the owner.
ground wire provided on permanently
connected units. Be sure that branch
circuit is grounded.
in tables and install a single branch
circuit. All wiring must comply with
local and national codes.
only.