Epson Progression U12 - Manual (Page 162)

Accessing Your System
If you have forgotten your current password, follow these steps
to access your system:
1.
2.
Turn off the computer.
Follow the instructions under “Jumper Settings” in Chapter 3
to disable the password function by setting jumper JP6 to
position A.
3.
4.
5.
Turn on the computer.
When you see Press to run SETUP, press
You see the SETUP screen. If you do not want to set a new
password, go to step 7. If you want to set a new password,
go to step 6.
6. To set a new password, highlight Password and press
Then press Type a new password at the prompt and
press You must enter the new password twice. (See
Chapter 2 of the Setup Guide for more information about
setting a password.) Now go to step 8.
7. To disable password checking, highlight Password
security and press Then press or to
change the setting to Not installed. (See Chapter 2 of
the Setup Guide for more information.)
8. Save your settings as you exit SETUP. (See Chapter 2 of the
Setup Guide for instructions.)
9. Turn off the computer.
10. Follow the instructions under “Jumper Settings” in
Chapter 3 to enable the password function by setting
jumper JP6 to position B.
7-10 Troubleshooting