LG Simple Remote Controller Thermostat Use and Care Guide - Manual (Page 9)

OPERATION INSTRUCTIONS - Sub function
17
ENGLISH
16
OPERATION INSTRUCTIONS - Sub function
ENGLISH
It is the function to prevent children or others
from careless using.
1 Press button and botton for 3 sec-
onds, you can operate child lock.
2 As for the releasing method, press
button and botton for 3 seconds.
h At the time of initial setting of the ‘Child
Lock’, the ‘CL’ will be indicated approx. 3
seconds at the temperature display section
before resuming to the previous mode.
h After the setting of the ‘CL’, if another but-
ton is setup, the button can not be recog-
nized as the ‘CL’ is indicated at the
temperature display section for approx. 3
seconds.
It is the function to operate WLAN (Wireless
LAN) module connected to the product in ac-
cess point mode.
1 Press button for 3 seconds.
2 Press button to move the WLAN mod-
ule access point mode.
3 While WLAN module is operating in ac-
cess point mode, the term of 'AP' blinks
on the screen of wired remote controller.
4 Press button for 3 seconds.
h This function is only available for select
models that support the WLAN Module.
h Refer to the installation manual of indoor
unit whether available or not.
It is the function to reinforce the heating capa-
bility by turning on the electric heater during
the heating operation.
1 Press button for 3 seconds.
2 Press button to move the heater
mode.
3 Press button to select heater mode
‘on/off’
4 Press button for 3 seconds.
h This function may not work in some prod-
ucts.
This function is to adjust airflow angle.
1 Press button for 3 seconds.
2 Press button to move the vane angle
control mode.
3 Press button to select indoor unit
vane. (1,2,3,4,All)
4 Press button to change the vane angle.
(P1 ~ P6)
5 Press button to set vane angle.
6 Press button for 3 seconds.
P1
P2
P3
P4
P5
P6
Child Lock Vane angle control
Heater
h As for the releasing method, press
button and botton for 3 seconds.
This function prevents changes to mode set-
ting.
1 Press button and button simulta-
neously for 3 seconds to use mode lock.
h If you press the button while mode
lock is in use, the following screen appears.
Mode lock button
WLAN module access point
mode
1,MFL62862020,영영 2018. 1. 3. 영영 1:01 Page 16