LG Simple Remote Controller Thermostat Use and Care Guide - Manual (Page 7)

12
OPERATION INSTRUCTIONS - Standard operation
ENGLISH
OPERATION INSTRUCTIONS - Sub function
13
ENGLISH
1 Press button to select auto mode.
2 Press buttons and then temperature
will blink.
3 You can control the blinking temperature
by pressing bottons.
This function automatically manages room
temperature based on set temperature and
provides a comfortable environment.
1 Press button for 3 seconds, you can
operate/cancel setback.
h You cannot change the setting in setback
operation, except to cancel the mode.
- ‘HL’ lock is displayed on the window.
Auto operation (Single set point)
NOTE !
• When remote controller has a connec-
tion with indoor unit that does not sup-
port 'dual setpoint', thermal operation
function of indoor unit is replaced with
ON/Off control from the wired remote,
when the user sets target tempera-
tures in the below ranges.
- cooling target temp. range :
87~99 °F (30.5~37.5 °C)
- heating target temp. range :
40~59 °F (4~15.5 °C).
For the case of cooling only model, you can
adjust the temperature from hot to cold, from
"-2" to "2" based on "0".
2 : When cold
1 : When cool
0 : When appropriate
-1 : When warm
-2 : When hot
1 Press button for 3 seconds, you can
operate/cancel override.
h You cannot change the setting in override
operation, except to set sub function and
cancel the mode.
- ‘HL’ lock is displayed on the window.
- It is only applied for ‘UNOCCUPIED’.
Heating operation state
Override
The override operation temporarily returns to
the set temperature until the override opera-
tion is canceled.
Setback
The setback operation returns to the set tem-
perature until the setback operation is can-
celed.
OPERATION INSTRUCTIONS - Sub function
1,MFL62862020,영영 2018. 1. 3. 영영 1:01 Page 12