Whirlpool 27 Inch Ventless Electric Dryer Installation Instructions - Manual (Page 3)

3
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver #2 Phillips screwdriver
Wire stripper (direct wire
installations)
Channel locks
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
1/4" and 5/16" nut driver
(recommended)
Utility knife Tape measure
Level Pliers
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
If using a power supply cord:
Use a UL Listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
■ A UL Listed 30 A power supply cord, rated 120/240 V
minimum. The cord should be type SRD or SRDT and
be at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
■ A UL Listed strain relief.
Additional Accessories: (Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
Parts supplied:
6' (1.82 m) drain
hose with couplers
Cable ties (2)