Whirlpool 27 Inch Ventless Electric Dryer Installation Instructions - Manual (Page 17)

17
3.
Move the door strike
Using a T25 ® screwdriver, remove the two screws securing
the door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame with
the two screws removed earlier, as shown.
2.
Remove door from dryer
IMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a T25 ® screwdriver, remove the four screws securing
the door hinge to the dryer and lift the door up and out to
remove. Place the door on a soft towel or other non-scratch
surface.
ALL DOORS:
4.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door.
5.
Remove hinge
Using a T20 ® screwdriver, remove the six screws holding the
hinge assembly in place.
Hinge
Top of
door