Extron Electronics DVS 406 Series - Manual (Page 5)

QS-3 DVS 406 • Quick Start
Output
Configuration
NEXT
Audio #6 Level
0.0 dB
Audio Switch
Start
NEXT NEXT
Audio level
• -15 dB to +9.0 dB in 1 decibel
increments (-15 dB default)
NOTE
Audio switching effects
• Start (default)
• Middle
• End
• Fade
Audio
Configuration
MENU
3
NEXT
IN #4 SAVE as
1 2 3
IN #4 Clear
1 2 3
NEXT NEXT
Saving (SAVE) memory presets
• Save the currently selected input's
sizing and centering information
• Up to 3 presets per input can be
selected < > (N/A is the default) and
saved.
• Save a preset by pressing the NEXT
button. This submenu will also advance
to the Clear submenu.
Clearing (Clear) memory presets
• Clear the currently selected input's
saved sizing and centering
information
• Up to 3 presets per input can be
selected < > (N/A is the default)
and cleared.
• Clear a preset by pressing the
NEXT button. This submenu will
also return to the Memory presets
menu.
Audio
Configuration
Memory
Presets
MENU
4
3 Audio Configuration menu
4 Memory Presets menu
5 Advanced Configuration menu
MENU
Memory
Presets
Switch Mode
Auto
NEXT
Advanced
Configuration
Effect Type
Cut
NEXT
Edge Smoothing
Off
NEXT
Top Blanking Bot
000 000
NEXT
RGB Delay
0.0 Seconds
NEXT
Blue Mode
On
NEXT
Key Mode
On
NEXT
2:2 Pull Down
NEXT
NEXT
Either Adjust knob is used
to adjust the submenus.*
To reset the scaler, press
Take button, then press
again to confirm
*Adjust knobs do not affect
this submenu.
RGB to video input
switching effect
• Cut (default)
• Dissolve: ranges from 0.2
to 1.0 seconds in 0.1 sec
increments
Smooth edges
• On (default)
• Off
Top and bottom blanking
• Top blanking: ranges from
000 (default) to 127.
Use
• Bottom (Bot) blanking:
ranges from 000 (default)
to 127. Use
RGB delay time
(in seconds)
• 0.0 (default) to 5.0
seconds in 0.5 second
increments
Switch mode switches to
next input:
• when Take button is
pressed (default)
• automatically (Auto) when
input button is pressed
Display blue and sync only
• On
• Off (default)
Set input switching to key
mode
• On
• Off (default)
Enhanced Mode
On
NEXT
Off
Press and Hold
TAKE to Reset
NEXT
Enhanced mode
(gain control)
• On
• Off (default)
PAL film mode
(2:2 pull down detection)
• On
• Off (default)
5