Extron Electronics DVS 406 Series - Manual (Page 26)

Installation and Operation, cont’d
DVS 406 • Installation and Operation 2-14
Extron
DVS 406
Output
Configuration
MENU
NEXT
IN #4 SAVE as
1 2 3
IN #4 Clear
1 2 3
NEXT NEXT
Input
Configuration
MENU
Saving (SAVE) memory presets
• Save the currently selected input's
sizing and centering information
• Up to 3 presets per input can be
selected < > (N/A is the default) and
saved.
• Save a preset by pressing the NEXT
button. This submenu will also
advance to the Clear submenu.
Clearing (Clear) memory presets
• Clear the currently selected input's saved
sizing and centering information
• Up to 3 presets per input can be selected
< > (N/A is the default) and cleared.
• Clear a preset by pressing the NEXT
button. This submenu will also return to
the Memory preset menu.
Audio
Configuration
MENU
Memory
Presets
MENU
Save (SAVE) memory presets
From this submenu, the sizing and centering information for the currently
selected input can be saved to memory. Up to three memory presets can be saved
per input: presets 1, 2, and 3.
Using either the horizontal Adjust ( ) or vertical Adjust ( ) knob, select (< >)
either N/A, 1, 2, or 3 to select a preset. The default is . To save the preset,
press the NEXT button.
Clear memory presets
From this submenu, up to three saved presets for the currently selected input can
be cleared from memory.
Using either the horizontal Adjust ( ) or vertical Adjust ( ) knob, select (< >)
either N/A, 1, 2, or 3 to select a preset. The default is . To clear the preset,
press the NEXT button.
Recalling a preset
Recalling an input’s saved preset requires that the input be selected and that the
input button be then pressed successively to recall any saved preset (up to three
saved presets). The available presets are sequentially selected in a loop*: preset
1, preset 2, preset 3, preset 1, preset 2, and so forth, depending on which presets
are available.
Each saved preset will display the LCD message “Input #X Memory Y” where
“X” refers to the input (2 to 6) and “Y” refers to the preset (1 to 3). The absence of
any saved presets will not display the LCD message for the missing preset.
* The actual presets will depend on what presets (1, 2, or 3) have been saved for
an input. For example, if only presets 1 and 3 are available, the sequential
looping of the presets as the input button is repeatedly pressed, will be: preset 1,
preset 3, preset 1, preset 3, and so forth.