Before operating, Stop/clear, Time cooking – Fulgor Milano 24 Inch Countertop Microwave Oven Use and Care Manual User Manual
Page 11: 5 - before operating

EN
9
Before Operating
Before operating your new microwave oven make sure you
read and understand this Use and Care Manual completely.
Before the oven can be used, follow these procedures:
Plug in the oven. Close the door. The oven display will
show:
WELCOME PRESS CLEAR AND PRESS CLOCK
1. Touch the STOP/CLEAR pad. : will
appear.
2. Set clock.
To Set the Clock
This is a 12 hour clock. If you attempt to enter an incorrect
clock time, ERROR will appear in the display. Touch the
STOP/CLEAR pad and re-enter the time.
• Suppose you want to enter the correct time of day 12:30
(A.M. or P.M.).
1. Touch TIMER/CLOCK pad and
number 2.
2. Enter the correct time of day touching
the numbers in sequence.
3. Touch TIMER/CLOCK pad again.
• If the electrical power supply to your microwave oven
should be interrupted, the display will intermittently show
WELCOME PRESS CLEAR AND PRESS CLOCK after the
power is reinstated. If this occurs during cooking, the
program will be erased. The time of day will also be
erased. Simply touch STOP/CLEAR pad and reset the
clock for the correct time of day.
Stop/Clear
Touch the STOP/CLEAR pad to:
• Erase if you make a mistake during programming.
• Cancel timer.
• Stop the oven temporarily during cooking.
• Return the time of day to the display.
• Cancel a program during cooking, touch twice.
Time Cooking
Your oven can be programmed for 99 minutes and 99
seconds (99.99). Always enter the seconds after the minutes,
even if they are both zeros.
• Suppose you want to cook for 5 minutes at 100%.
1. Enter cooking time.
2. Touch START.
5 - BEFORE OPERATING
To Set Power Level
There are eleven preset power levels.
Using lower power levels increases the cooking time which
is recommended for foods such as cheese, milk and long
slow cooking of meats. Consult cookbook or recipes for
specific recommendations.
TOUCH POWER LEVEL
PAD NUMBER OF TIME
FOR DESIRED POWER
APPROX. %
OF POWER
COMMON WORDS
FOR POWER LEVELS
POWER LEVEL x 1
100%
High
POWER LEVEL x 2
90%
POWER LEVEL x 3
80%
POWER LEVEL x 4
70%
Medium High
POWER LEVEL x 5
60%
POWER LEVEL x 6
50%
Medium
POWER LEVEL x 7
40%
POWER LEVEL x 8
30%
Med Low/Defrost
POWER LEVEL x 9
20%
POWER LEVEL x 10
10%
Low
POWER LEVEL x 11
0%
• Suppose you want to defrost for 5 minutes at 30%.
1. Enter defrosting time.
2. Touch POWER LEVEL pad eight times
or hold down until the desired power
appears.
3. Touch START.
When the defrost time is complete, a long tone will sound
and END will appear in the display.