Eagle Electronics FISHEASY 240 User Manual

Page 36

Speed sensor mounting configuration:

side view (left) and rear view (right.)

If the base of the transom has a radius, fill the gap between the tran-

som and the sensor with the caulking compound. This will help ensure

a smooth water flow.
Route the sensor's cable through or over the transom to the sonar unit.

If you need to drill a hole in the transom to pass the connector through,

the required hole size is 5/8".
Caution:

If you drill a hole in the transom for the cable, make sure it is
located above the waterline. After installation, be sure to seal the
hole with the same marine grade above- or below-waterline seal-
ant used for the screws.

The sensor is now ready for use. Connect the sensor to the accessory

socket on the back of the unit. If you have any questions concerning the

installation of the sensor, please contact your local boat dealer.
Power Connections
(permanent mount units only)
The unit works from a 12-volt battery system. You can attach the

power cable to your boat's accessory or power buss (or directly to the

battery). If you use an accessory buss but have problems with electrical

Transom

Bottom of hull